![]() ![]() Other suggestions? I really don’t want to spend 5 to 7 days syncing bitcoin network again using umbrel if I don’t understand why this happened or how to fix it. Even after flashing new sdcard with umbrel and booting up, then sshing in and entering the commands above to stop service, prune docker and start service again, I still get the messages below from journalctl -xe regarding docker failing to start when I had not changed anything (only power was disconnected and reconnected). Sep 16 05:04:29 umbrel sudo: pam_unix(sudo:session): session closed for user root – The unit docker.socket has entered the ‘failed’ state with result ‘service-start-limit-hit’. Sep 16 05:04:29 umbrel systemd: docker.socket: Failed with result ‘service-start-limit-hit’. – The job identifier is 5832 and the job result is failed. – Support: – A start job for unit rvice has finished with a failure. – Subject: A start job for unit rvice has failed Sep 16 05:04:29 umbrel systemd: Failed to start Docker Application Container Engine. P 16 04:55:31 umbrel systemd: Failed to start Docker Application Container Engine.įrom journalctl -xe i- The unit rvice has entered the 'failed' state with result 'exit-code'. ![]() P 16 04:55:31 umbrel systemd: rvice: Failed with result ‘exit-code’. P 16 04:55:31 umbrel systemd: rvice: Start request repeated too quickly. P 16 04:55:19 umbrel systemd: Failed to start Docker Application Container Engine. P 16 04:55:19 umbrel systemd: rvice: Failed with result ‘exit-code’. P 16 04:55:19 umbrel systemd: rvice: Start request repeated too quickly. P 16 04:55:07 umbrel systemd: Failed to start Docker Application Container Engine. P 16 04:55:07 umbrel systemd: rvice: Failed with result ‘exit-code’. P 16 04:55:07 umbrel systemd: rvice: Start request repeated too quickly. P 16 04:55:04 umbrel systemd: Failed to start Docker Application Container Engine. Process: 4652 ExecStart=/usr/bin/dockerd -containerd=/run/containerd/containerd.sock (code=exited, status=2) Loaded: loaded (/lib/systemd/system/rvice enabled vendor preset: enabled)Īctive: failed (Result: exit-code) since Thu 04:55:04 UTC 27s ago Upon power up pi boots up normally but docker will not start with the following error message rvice - Docker Application Container Engine Power was disconnected from pi and reconnected. I had for several weeks a perfectly running umbrel. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |